By joseph pettit
Read Online or Download Electronic Amplifier Circuits Theory and Design PDF
Best electronics books
Engineer's Mini-Notebook: Optoelectronics Circuits
This e-book comprises standart program circuits and circuits designed by way of the writer
Diagnostic Electron Microscopy: A Text Atlas (2nd Ed.)
This article atlas, now in its moment version, offers in easiest shape the fundamental diagnostic standards utilized by the electron microscopist in learning neoplasms and different ailments encountered within the regimen perform of pathology. each box of electron microscopy is roofed and coffee magnification plates are juxtaposed with greater magnifications to demonstrate diagnostic good points.
- Electronics for Beginners
- Optoelectronic Devices: Design, Modeling, and Simulation
- Computer Music: Synthesis, Composition, and Performance
- Intuitive IC OP Amps
- Make: Getting Started with Adafruit Trinket: 15 Projects with the Low-Cost AVR ATtiny85 Board
Additional info for Electronic Amplifier Circuits Theory and Design
Sample text
SBWTDIO and SBWTCK provide the Spy-Bi-Wire interface, an alternative to the usual JTAG connection that saves pins. A less common feature of the MSP430 is that some functions are available at several pins rather than a single one. This applies to Timer_A in the F2013. 5 is available only for output. 6. 2 can be configured for input to the timer. The details are set out in the table of Terminal Functions in the data sheet and explained further in the section on Timer_A2. One of the first tasks in a program for a microcontroller is to configure the functions of each pin.
025 ) apart. A general warning: Packages with the same shape do not always have the same pin-out. This does not apply to the F2013, but I have been caught out by other companies’ products. 65 mm apart. This has 16 leads instead of 14, which allows the analog and digital power connections to be brought out separately for better performance. 1. Perhaps the most obvious feature is that almost all pins have several functions. This is typical of a modern, small microcontroller. Silicon is cheap but pins are expensive.
There are ground and power supply connections. Ground is labeled VSS and is taken to define 0 V. The supply connection is VCC . 6 V is specified for the F2013. The performance of the device depends on VCC . 3 V. TI uses a quaint notation for the power connections. The S stands for the source of a field-effect transistor, while the C stands for the collector of a bipolar junction transistor, a quite different device. The MSP430, like most modern integrated circuits, is built using complementary metal–oxide–silicon (CMOS) technology and field-effect transistors.